xxiii
● Machinery Directive
The Machinery Directive requires ensuring the required safety for safety components used for machin-
ery safety.
Applicable standards: EN ISO 13849-1:2015 and IEC/EN 62061 SIL CL3
● Conformance to EC Directives
The G9SP-series Controller complies with EC Directives. To ensure that the machine or device in which
the G9SP-series Controller is used complies with EC Directives, the following requirements must be
met.
• Make sure that the DC power supply connected to a DC Power Supply Unit or I/O
Unit satisfies the following conditions.
• There is double insulation or reinforced insulation between the primary cir-
cuit and secondary circuit.
• An isolated power supply that is limited to a current of 8 A or lower must be
used.
• The output hold time is 20 ms min.
• The power supply is a SELV power supply that satisfies requirements in IEC/
EN 60950-1 and EN 50178.
• G9SP-series products that comply with the EC Directives also comply with the
Generic Emission Standard (EN 61000-6-4) for EMI. The radiated emission charac-
teristics (10-m regulations), however, may depend on the configuration of the control
panel that is used and the relation to and wiring with other connected devices. Even
through the G9SP-series Controller complies with EC Directives, the customer must
confirm that the overall machinery and equipment in which the G9SP-series Control-
ler is used complies with the EC Directives.
EN ISO 13849-1 and IEC/EN 62061 require process management to avoid system interference and to
simplify reading, understanding, testing, and maintaining software. This is required in all phases of the
life cycle of software programming and software design (e.g., basic software design, safety circuit sys-
tem design, and software upgrades) in safety control systems to be developed using safety controllers.
Therefore, process management is required for design and development of software for facilities and
equipment that use the function blocks provided in the Safety Controller.
The customer must implement measures to ensure compliance with these standards.
To obtain the reliability data for safety of machinery to verify the safety performance of your equipment,
go to the following URL: http://www.ia.omron.com/support/sistemalibrary/index.html.
EN ISO 13849-1 and IEC/EN 62061 Compliance
To Next Page
Loading...
