22
G9SP-series Controllers Section 2-1
Connecting Safety Devices with Semiconductor Outputs
Connecting a safety light curtain is described here as an example of connect-
ing Safety Devices with semiconductor outputs.
Wiring Example
A 24-VDC semiconductor output, such as the OSSD output from the safety
light curtain, is input.
Errors in the OSSD output signal line are detected by the externally con-
nected device.
G9SP Configurator Setting Example
Connecting an OMRON E3ZS/E3FS Single Beam Safety Sensor
This section describes connecting an OMRON E3ZS/E3FS Single Beam
Safety Sensor.
Wiring Example
The OSSD 24-VDC semiconductor output from the Single Beam Safety Sen-
sor is input.
G9SP Configurator Setting Example
Si0
Si1
Safety
Light Curtain
Control output 1 (OSSD 1)
24 VDC
0V
24 V
0V
0 V
Emitter
Receiver
Control output 2 (OSSD 2)
24 VDC
0 V
T3
Si0
Light transmitter
Single Beam
Safety Sensor
Receiver
24 V (Brown)
0 V (Blue)
Test input (Pink)
Control output (Black)
24 V (Brown)
0 V (Blue)
Mode (Pink)
L1 + L2 ≤ 100 m
L
1
L2
To Next Page
Loading...
