Omron LD-250 - Wheel Lift Tool

146 LD-250 Platform User's Guide 20472-000 Rev B
8.5 Wheel Lift Tool
!
CAUTION: PROPERTYDAMAGE RISK
Lifting the LD-250 from the wrong points can cause damage.
!
DANGER: PERSONALINJURYORPROPERTYDAMAGERISK
When lifting the LD-250 take all precautions to lift it safely at only the des-
ignated lift points and to secure the LD-250 when it is in an elevated position.
Do not work under the LD-250 if it is not secured in the lifted position with
safety straps. Failure to do so might result in serious personal injury or death
or damage to property.
Safe lifting points are:
l
load-bearing T-slotted extrusions in the payload bay.
l
The caster mount points.
l
Any part of the underside of the steel chassis that is not a sensor location.
Do not lift the LD-250 by:
l
Any of the skins.
l
Any part of the chassis that contains a sensor component.
8.5 Wheel Lift Tool
A wheel lift tool is provided so that you can lift the drive wheels for maintenance tasks. This
tool is located on the right side of the LD-250, underneath the side skin as shown in Figure 8-2.
Figure 8-2 Location of the Wheel Lift Tool