186 LD-250 Platform User's Guide 20472-000 Rev B
8.10 Replacing Non-Periodic Parts
Restoring the Configuration
You can restore the AMR's configuration from:
l A saved debuginfo or configuration file.
l A default model file distributed on the software USB thumbdrive.
A restore operation is required after replacing an LD-250 Core.
If you accidentally upload an incorrect configuration file for a different LD model the LD-250
cannot operate. During start up, it detects the incorrect file type and an error message instructs
you to run the Recovery Mode procedure.
You use the SetNetGo operating system's backup and restore options to recover a con-
figuration. For information about recovery procedures, see: Fleet Operations Workspace Core
User's Guide.
To Next Page
Loading...
