Omron LD-250 - Configure the Maintenance Network

Chapter 1: Introduction
3.
Click Status and select Debug Info from the left pane.
4.
Click Download Debug Info and then specify a location to save the file.
Otherwise, you must first create a TCP/IP connection to the AMR's maintenance Ethernet port
as described in: Configure the Maintenance Network on page 25.
Configure the Maintenance Network
Use this procedure only if you have not configured your LD-250 for access over a wireless net-
work. Instead, you use a hardwired connection to the LD-250 maintenance port. (See: Main-
tenance Ethernet Connection on page 67.)
1.
Connect a Cat-5 (minimum) Ethernet cable from the maintenance Ethernet port on the
LD-250 to an Ethernet port on your Windows PC.
2.
In the Windows Open or Search box (or at a command prompt) type the following com-
mand and press Enter:
ncpa.cpl
This command opens the Network Connections screen, which might look different
depending on your version of Windows.
Figure 1-8 Network Connections Screen.
3.
Right-click on the Ethernet N or LAN Connection.
4.
Click Properties, and then double-click the Internet Protocol Version 4 connection item
to open its Properties window.
20472-000 Rev B LD-250 Platform User's Guide 25