Chapter 8: Maintenance
Table 8-2 Cleaning
Item Period
Clean docking station
contacts
3 months
Clean axles and tires As needed
Clean dust and dirt from drive assembly and suspension well. As needed
Clean all lasers 6 months/ as needed
NOTE: The frequency of these procedures depend on your particular system, its
operating environment, and the amount of use. Operating in a dusty or dirty
environment requires more frequent cleaning. Use the intervals in this section as
guidelines, and modify the schedule as needed.
Wheels
Occasionally clean the treads with a mild soapy solution. Remove any accumulated dirt or
debris on the tires which can degrade performance.
This applies to both the drive wheels and the casters.
Axles
Keep the axles free of fibrous material, plastic film or any materials that might wrap around
and bind up the LD-250’s axles.
Drive Assemblies
Remove any accumulated dirt and dust.
1.
Before and after cleaning, inspect all mechanical parts for breakage or signs of wear
which might be indicated by:
20472-000 Rev B LD-250 Platform User's Guide 153
To Next Page
Loading...
