Omron LD-250 - Page 166

166 LD-250 Platform User's Guide 20472-000 Rev B
8.10 Replacing Non-Periodic Parts
WARNING: ELECTROCUTIONRISK
Unplug power from the docking station before you remove fuses. Remove the
power cord from the charger.
To replace a fuse:
1.
Remove eight screws from the back cover of the docking station and one each from the
bottom side panel.
Figure 8-15 Docking Station Rear Cover Screws (8 of 10)
Retain the screws for reassembly.
2.
Remove the docking station's rear cover.
3.
Identify the fuse holder shown in Figure 8-16. It is close to the top of the bus-bar (A) in a
black screw-top holder (B)