84 LD-250 Platform User's Guide 20472-000 Rev B
5.2 Considerations
Use T-nuts appropriate for the mass of your payload. To maintain access to the payload bay,
consider incorporating hinged attachment points on one side of your payload structure so that
you can tilt it away from the bay.
Secondary Mount Points - Top Plate Clip Nuts
Clip nuts (14) around the rim of the top plate can accept smaller loads such as payload skins
or covers. These locking-thread M6 clip nuts provide attachment points for the standard top
skin option provided for the LD-250.
IMPORTANT: Do not use the clip nuts to support the payload itself, make all
load-bearing attachments only to the T-slot aluminum extrusions.
Figure 5-4 shows the approximate positions of the clip nuts relative to the edge of the top
plate and its center lines. You can obtain the CAD and engineering drawing sources from the
Omron Web site if you need to determine the precise locations.
To Next Page
Loading...
