68
•
The standard location is in the top right corner of the workbed. This can be
changed by moving either your design or the engraver’s origin position using
the control panel or your engraving software.
•
If you will be adjusting the laser head or its nozzles, it can be helpful to
briefly cover the material with something soft and wide to catch any loose
parts that might accidentally be dropped during the process. Remove any
such material before engraving.
•
For heavier pieces of material, be careful to distribute its weight as evenly
as possible across the reinforced supports. For larger pieces of material, you
may open the front, rear, or side pass-through doors.
Step 3. Place a sample piece of your material on the workbed.
DO NOT insert anything through the pass-through doors other than the material
once the laser is active. Pay special attention to the fumes and dust that may
be released through these doors. Be sure that your ventilation system is strong
enough to pull in all of the byproducts or wear the necessary PPE to ensure the
health of users and passersby.
To Next Page
Loading...
