OPTIMedical OPTI CCA-TS - Checking the Printer

Operator’s Manual – OPTI CCA-TS 7-19
7 DIAGNOSTICS AND TROUBLESHOOTING
7.2.12 Checking the Printer
This diagnostic function lets you check for the
proper functioning of the built-in thermal printer.
To activate:
From the <Ready> display, press <System
Manager> and <Diagnostics>.
• Select the <Tests> tab.
•
Press <Printer> to start the test (Fig. 7-15).
• The printer will output a test print.
• Check if the alphanumeric printout is legible and
all the characters are properly printed.
If the printout is decient, your printer may need
replacement.
To replace the printer, follow the steps below.
• Turn the OPTI CCA-TS off.
• Remove the paper roll and pump cartridge.
• Unscrew the two thumbscrews holding the
printer in place.
• Pull printer up and out towards the paper tray.
• Disconnect the cable from the receptacle.
• Install the new printer in reverse order.
Fig. 7-15 Printer Test