OPTIMedical OPTI CCA-TS - Control Calibration Report

Operator’s Manual – OPTI CCA-TS 7-31
7 DIAGNOSTICS AND TROUBLESHOOTING
7.2.22.3 Control Calibration Report
The <Control Calibration Report> shows details
of measured signals in millivolts as well as drifts
observed during measurement.
• To print a controls report, select <Calibration
Reports ->Controls> in the <Data> screen
(Fig. 7-49).
• In the <Data - Control Diagnostics> screen
(Fig. 7-50), select the desired measurement and
press the
button to display the control
results (Fig. 7-51). Use the and
buttons to display the previous or next
page of results.
• To print individual results, highlight the desired
measurement (Fig. 7-50). To print groups
of results, highlight the rst measurement
to be printed, press
, then select
the last measurement to be printed. All the
measurements in between will be selected.
Press
to select all results.
• Press to print your selection.
• Press
to return to the <Data> screen.
Fig. 7-50 Select Measurement
Fig. 7-49 Select Control
Fig. 7-51 Control Diagnostics