7-30 Operator’s Manual – OPTI CCA-TS
7 DIAGNOSTICS AND TROUBLESHOOTING
7.2.22.2 SRC Calibration Report
The <SRC Calibration Report> shows details
of measured signals in millivolts as well as drifts
observed during the measurement.
• To print an SRC report, select <Calibration
Reports -> SRC> in the <Data> screen
(Fig. 7-46).
• In the <Data - SRC Diagnostics> screen
(Fig. 7-47), select the desired measurement
and press the
button to display the
SRC results (Fig. 7-48). Use the and
buttons to display the previous or next
page of results.
• To print individual results, highlight the desired
measurement (Fig. 7-47). To print groups
of results, highlight the rst measurement
to be printed, press
, then select
the last measurement to be printed. All the
measurements in between will be selected.
Press
to select all results.
• Press to print your selection.
• Press
to return to the <Data> screen.
Fig. 7-46 Select SRC
Fig. 7-47 Select Measurement
Fig. 7-48 SRC Diagnostics
To Next Page
Loading...