OPTIMedical OPTI CCA-TS - Running an SRC Measurement

4-4 Operator’s Manual – OPTI CCA-TS
4 CALIBRATION AND QUALITY CONTROL
4.5.1 Running an SRC Measurement
1. From the <Ready> display, select
<QCManager>.
2. Select <SRC> (Fig. 4-1).
3. Enter your Operator ID, or 4-digit PIN using the
alphanumeric keypad (Fig. 4-2).
To bypass this function, press
.
NOTE: IfOperatorIDisconguredas“required”
inSetup,youcannotgotothenextstep
unlessavalidOp.IDisentered.
NOTE: IfSecureOp.IDsisactivatedunderSetup,
youwillbepromptedforyour4-digitPIN#
insteadofyourOp.ID.
NOTE: Bar-codedOperatorIDsmaybeentered
usingthebarcodescanner.
4. Open the sample chamber cover by pressing the
button (Fig. 4-3).
Fig. 4-1 Select SRC
Fig. 4-3 Open Cover
Fig. 4-2 Enter Operator ID