OPTIMedical OPTI CCA-TS - Lactate Setup

7-26 Operator’s Manual – OPTI CCA-TS
7 DIAGNOSTICS AND TROUBLESHOOTING
7.2.20 Lactate Setup
The <Lactate Setup> menu is used to enable the
running of lactate cassettes. New analyzers from
OPTI Medical are already set up for the lactate
parameter and do not require this step. Only follow
this procedure if you wish to set up B-Lac cassettes.
The lactate setup procedure only has to be
performed once on your analyzer. The setup will
permanently enable B-Lac cassettes on your
analyzer. The setup is not cleared by power loss,
software upgrades, reset, or otherwise clearing the
analyzer’s database.
This is not a troubleshooting procedure.
Call Technical Support for further assistance.
From the <Ready> display, press <System
Manager -> Diagnostics>.
• Select the <Tests> tab.
•
Press <Lactate Setup> (Fig. 7-35).
•
Enter the setup password 404 to access the
setup functions. If the factory-set password was
changed, enter the currently valid password.
•
Enter the Operator ID or press to
bypass this function (Fig. 7-36).
If Operator ID is congured as “required” in
Setup, you cannot go to the next step unless a
valid Op. ID is entered.
If Secure Op. IDs is activated under Setup, you
will be prompted for your 4-digit PIN # instead
of your Op. ID.
This message (Fig. 7-37) is displayed if lactate is
already set up.
•
Press to keep the current settings and
cancel the setup process.
•
Press to start the setup process.
Fig. 7-35 Lactate Setup
Fig. 7-37 Lactate Setup
Fig. 7-36 Enter Operator ID