Operator’s Manual – OPTI CCA-TS 8-15
Calibration Gas, BP7001
Use: For calibration of pH, PCO
2
and PO
2
in the OPTI CCA-TS Analyzer.
Contents: Each disposable, low pressure cylinder contains approximately 2 liters of
gas (at less than 145 psi at 21 °C)
Composition: Oxygen 14.0 ± 0.02%
Carbon Dioxide 6.0 ± 0.02%
Nitrogen balance
Storage: Refer to package labeling.
Battery Charger (Optional), BP7036
Use: For fast charging of extra battery pack for the OPTI CCA-TS.
Contents: Each charger contains a power supply with circuitry.
Input voltage: 100-240 VAC, 50-60 Hz
Storage: Refer to package labeling.
Precautions
Use of calibration solutions, calibration gas, or optodes not manufactured by OPTI Medical
Systems could void the warranty.
Once used, the sample cassette holds human body uids which may be potentially infectious;
handle with appropriate care to avoid skin contact or ingestion.
For in-vitro diagnostic use.
For professional use only.
Bibliography
1. Guilbault GG, Ed., Practical Fluorescence, 2nd Edition, Marcel Dekker, 1990
2. Tietz; Burtis C, et al (Eds.), Textbook of Clinical Chemistry and Molecular Diagnostics, 4
th
Ed.,
(Elsevier Saunders, 2006) pps. 2252-2302.
3. Mahoney JJ, Wong RJ, Van Kessel AL, Reduced Bovine Hemoglobin Solution Evaluated for Use as a
Blood Gas Quality Control Material. Clin.Chem.39/5,874-79 (1993)
4. J.B.Henry, Clinical Diagnosis and Management by Laboratory Methods, 19th Ed., 1996, p.590,777
5. Clinical and Laboratory Standards Institute (CLSI). Interference Testing in Clinical Chemistry;
Approved Guideline - 2nd Edition. CLSI document EP7-A2. CLSI, Wayne, PA, 2005
To Next Page
Loading...