Remove a Memory Riser
Remove a Memory Riser
This is a cold-service procedure that can be performed by a customer. Power down the server
completely before performing this procedure.
Caution - This procedure requires that you handle components that are sensitive to ESD which
can cause server components to fail.
Note - Your server could include a memory riser that is secured with a flat-head screw. If that is
the case, use a No. 1 flat-blade screwdriver to service that memory riser.
1.
Prepare for servicing.
See “Preparing for Service” on page 47.
2.
Identify the memory riser with the faulty DIMM by pressing the Remind button on
the air divider as shown in the following figure.
100 SPARC T7-2 Server Service Manual • July 2019
To Next Page
Loading...
Need help?
General