Verify a Power Supply
Verify a Power Supply
1.
Verify that the power supply OK and AC Present LEDs are lit, and that the fault
LED is not lit.
See “Power Supply LEDs” on page 85.
2.
Verify that the front and rear Service Required LEDs are not lit.
See “Interpreting LEDs” on page 35.
3.
Consider these possibilities:
■
If any of the LEDs are illuminated, see “Interpreting LEDs” on page 35.
■
If none of the LEDs are illuminated, the power supply has been replaced successfully.
Related Information
■
“Determine Which Power Supply Is Faulty” on page 87
■
“Front Panel Components (Service)” on page 13
■
“Rear Panel Components (Service)” on page 15
90 SPARC T7-2 Server Service Manual • July 2019
To Next Page
Loading...
