Replace the Top Cover
Replace the Top Cover
1.
Place the top cover on the chassis (panel 1).
A metal air baffle is attached to the rear inside surface of the top cover. When you place the top
cover on the server, ensure that the air baffle does not catch on anything inside the server.
Set the cover down so that it is about 1 inch (2.5 cm) forward of the rear of the server.
2.
Slide the top cover toward the rear of the chassis until the rear cover lip engages
with the rear of the chassis.
3.
Close the top cover by pressing down on the cover with both hands until both
latches engage (panel 2).
4.
Return the server to its normal operating position.
See “Return the Server to the Normal Operating Position” on page 173.
Related Information
■
“Remove the Top Cover” on page 62
172 SPARC T7-2 Server Service Manual • July 2019
To Next Page
Loading...
