Oracle SPARC T7-2 - Install a Drive

Install a Drive
3.
Install a drive or a replacement drive filler.
See “Install a Drive Filler” on page 74 or “Install a Drive” on page 72.
Related Information
■
“Determine Which Drive Is Faulty” on page 67
■
“Remove a Drive” on page 67
■
“Install a Drive” on page 72
■
“Install a Drive Filler” on page 74
■
“Verify a Drive” on page 75
Install a Drive
Installing a drive into a server is a two-step process. You must first install the drive into the
drive slot and then configure that drive to the server.
Note - If you removed an existing drive from a slot in the server, you must install the
replacement drive in the same slot as the drive that was removed. Drives are physically
addressed according to the slot in which they are installed.
1.
Take the necessary ESD precautions.
See “Prevent ESD Damage” on page 57.
2.
Fully open the release lever on the drive.
72 SPARC T7-2 Server Service Manual • July 2019