Oracle SPARC T7-2 - Verify a Fan Module

Verify a Fan Module
Verify a Fan Module
1.
Verify that the Service Required LED on the replaced fan module is not lit.
See “Fan Module LEDs” on page 78.
2.
At the Oracle ILOM prompt, start the fault management shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y

faultmgmtsp>
3.
Type fmadm faulty to check for faults.
■
If faults are reported, see “Detecting and Managing Faults” on page 29.
■
If no faults are reported, then the component has been replaced successfully.
4.
Consider these possibilities:
■
If any of the LEDs are illuminated, see “Interpreting LEDs” on page 35.
■
If none of the LEDs are illuminated, the fan module has been replaced successfully.
Related Information
■
“Determine Which Fan Module Is Faulty” on page 79
■
“Front Panel Components (Service)” on page 13
■
“Rear Panel Components (Service)” on page 15
Servicing Fan Modules 83