Oracle SPARC T7-2 - Identify Disabled Components

Identify Disabled Components
Identify Disabled Components
You can run the show disabled command from the Oracle ILOM prompt to identify
components that have been disabled either intentionally, by a user, or automatically, because of
a fault.
1.
At the Oracle ILOM prompt, type:
-> show disabled
Target | Property | Value
-----------------------------------+----------------+--------------------
...
/SYS/MB/CM0/CMP | disable_reason | Configuration Rules
...
2.
For additional information about a disabled component, type the show -t
command and the Oracle ILOM target.
See “Component Names Displayed by Diagnostic Software” on page 34.
For example:
-> show -t /SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM
Target | Property | Value
-----------------------------------+------------------------+------------
...
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | type | DIMM
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | ipmi name | P0/M3/B0/C1/D0
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | requested_config_state | Enabled
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | current_config_state | Enabled
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | disable_reason | Configuration Rules
/SYS/MB/CM0/CMP/MR3/BOB0/CH1/DIMM | fru_name | 8192MB DDR4 SDRAM DIMM
...
Related Information
■
“Log In to Oracle ILOM (Service)” on page 30
■
“Identify Faulted Components” on page 31
■
“Component Names Displayed by Diagnostic Software” on page 34
Detecting and Managing Faults 33