Oracle SPARC T7-2 User Manual

Verify the SPM
See “Power On the Server (Oracle ILOM)” on page 174 or “Power On the Server (System
Power Button)” on page 175.
12.
Verify the SPM.
See “Verify the SPM” on page 140.
Related Information
■
Oracle ILOM documentation
■
“Remove the SPM” on page 136
■
“Verify the SPM” on page 140
Verify the SPM
1.
Verify that the SPM Status LED is illuminated green.
The LED flashes green while the SPM initializes the Oracle ILOM firmware. See “Interpreting
LEDs” on page 35 for information about the status of the SPM LED.
2.
At the Oracle ILOM prompt, start the fault management shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y

faultmgmtsp>
3.
Type fmadm faulty to check for faults.
■
If faults are reported, see “Detecting and Managing Faults” on page 29 .
■
If no faults are reported, then the SPM has been replaced successfully.
Related Information
■
Oracle ILOM documentation
■
“Install the SPM” on page 137
140 SPARC T7-2 Server Service Manual • July 2019

Oracle SPARC T7-2 Specifications

General

Brand	Oracle
Model	SPARC T7-2
Category	Server
Language	English