Install the Fan Board
3.
Insert the fan board into the chassis, moving it down and toward the front (panel
1).
4.
Reposition the front memory riser guide, routing the fan board and power cable
through the riser guide (panels 2 and 3).
5.
Plug the fan board cable and power cable into the connectors on the
motherboard (panel 3).
Caution - When connecting the ribbon cable to the motherboard, take care to center the cable
on the connector before inserting the cable.
6.
Secure the fan board by reinserting and tightening the two screws on each side
of the outside of the chassis (panel 3).
7.
Tighten the three captive screws to hold the front memory riser guide in place
(panel 4).
144 SPARC T7-2 Server Service Manual • July 2019
To Next Page
Loading...
