Install the Drive Backplane
Note - The SAS cable connectors on the motherboard are labeled top and bottom. Plug the
both SAS cables into the drive backplane, then install the top SAS cable into the motherboard
connector labeled top. Install the other SAS cable into the bottom connector.
5.
Replace the System Remind button assembly (air divider).
6.
Replace all memory risers you removed.
See “Install a Memory Riser” on page 106.
7.
Replace the DVD drive.
See “Install a DVD Drive” on page 114.
8.
Replace all drives and filler panels.
See “Install a Drive” on page 72.
9.
Return the server to operation.
See “Returning the Server to Operation” on page 171.
162 SPARC T7-2 Server Service Manual • July 2019
To Next Page
Loading...
