Oracle X5-2 User Manual

Test the IPv4 or IPv6 Network Configuration
The Network Configuration Test screen appears.
b.
From the Test Type list box, select Ping (for an IPv4 configuration) or
Ping6 (for an IPv6 network configuration).
c.
Type the IPv4 or IPv6 test destination address in the Destination field
and click Test.
If the test was successful, the message Ping of ip_address succeeded confirmation
appears below the Destination field in the Network Configuration Test screen.
■ From the Oracle ILOM CLI, perform these steps:
a.
At the CLI prompt, type the show command to view the network test
targets and properties.
For example, the following output shows the test target properties:
-> show
/SP/network/test
Targets:
Properties:
ping = (Cannot show property)
92 Oracle Server X5-2 Installation Guide • January 2021

Oracle X5-2 Specifications

General

Number of Processors	2
Cores per Processor	Up to 18
Form Factor	2U Rackmount
Processor	Intel Xeon E5-2600 v3
Memory	Up to 768 GB DDR4
Power Supply	1200W
Operating System	Oracle Linux, Oracle Solaris
Network	4 x 10Gb Ethernet ports