Optional Component Installation
Caution - To protect electronic components from electrostatic damage, which can permanently
disable the system or require repair by service technicians, place components on an antistatic
surface, such as an antistatic discharge mat, an antistatic bag, or a disposable antistatic mat.
Wear an antistatic grounding strap connected to a metal surface on the chassis when you work
on system components.
Read the safety information in the Oracle Server X5-2 Safety and Compliance Guide and in the
Important Safety Information for Oracle's Hardware Systems before installing the server.
Caution - Deploy the anti-tilt bar or legs on the equipment rack before beginning an
installation.
Caution - The server weighs approximately 18.0 kg (40.0 pounds). Two people are required to
lift and mount this 1 rack unit (1U) server into a rack enclosure when using the procedures in
this document.
Caution - When completing a two-person procedure, always communicate your intentions
clearly before, during, and after each step to minimize confusion.
Related Information
■
“Safety Precautions” on page 41
Optional Component Installation
Standard system components are installed at the factory. Optional components that you
purchased independent of the standard configuration are shipped separately, and in most cases
should be installed before you install the server in a rack.
The following optional components can be ordered and purchased separately:
Preparing for Server Installation 25
To Next Page
Loading...
Need help?
General
