Configure the Preinstalled Oracle Solaris Operating System
Related Information
■
“Configure the Preinstalled Oracle Solaris Operating System” on page 134
■
“Oracle Solaris Operating System Documentation” on page 137
Configure the Preinstalled Oracle Solaris Operating
System
After you have completed the configuration worksheet, use the following procedure to
configure the preinstalled Oracle Solaris operating system.
1.
If you are not already logged in to Oracle ILOM, log in either locally from a serial
connection, or remotely from an Ethernet connection.
See “Connecting to Oracle ILOM” on page 83.
2.
Power on or reset the server, as follows:
■
To power on the server, use one of the following methods:
■
From the Oracle ILOM web interface, select Host Management → Power Control,
and then select Power On from the Select Action list box. Click Save, and then click
OK.
■
From the Oracle ILOM CLI, type the following command from the prompt:
-> start /System
When prompted, type y to confirm:
Are you sure you want to start /System (y/n)? y
Starting /System
■
To reset the server, use one of the following methods:
■
From the Oracle ILOM web interface, select Host Management → Power Control,
and then select Reset from the Select Action list box. Click Save, and then click OK.
■
From the Oracle ILOM command-line interface, type the following command from
the prompt:
-> reset /System
When prompted, type y to confirm:
Are you sure you want to reset /System (y/n)? y
The server begins the boot process.
3.
Start the remote host console using one of the following methods:
134 Oracle Server X5-2 Installation Guide • January 2021
To Next Page
Loading...
Need help?
General
