Oxford Instruments Omicron NanoScience MercuryiTC User Manual

Operator's Manual
Issue 05 /
Feb 2015 / UMC0071
MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 97
Max Rx input voltage ±30 V
7.2 Remote operation using GPIB
7.2.1 Configuring GPIB
• On the Home page, tap Settings.
• Scroll to the GPIB tab and select it.
The page contains one parameter box:
• GPIB Address
Select a GPIB address for this instrument from the drop-down menu.
NOTE: This sets the GPIB “Primary Address”. When using the SCPI command set the
GPIB “Secondary Address” is invoked. This is always set to 1 but must be set in any
applications trying to access the iTC using SCPI commands via GPIB. If the Legacy
command set is being used the “Secondary Address” is not invoked and therefore is not
required.
The page also contains the following buttons:

Oxford Instruments Omicron NanoScience MercuryiTC Specifications

General

Brand	Oxford Instruments Omicron NanoScience
Model	MercuryiTC
Category	Controller
Language	English