MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 101
To switch to remote:
• Tap Settings on the Home page and scroll to the General tab.
• Tap the Remote Access parameter box and select an interface from the drop-down menu.
• Tap Apply to enable the selected interface.
To switch to local:
• Tap Settings on the Home page and scroll to the General tab.
• Tap the Remote Access parameter box and select Local from the drop-down menu.
• Tap Apply to enable local control of the iTC.
7.6 Testing remote connections
An executable application for the PCs (WindowsXP and Windows7) is available from the
Mercury support website www.mymercurysupport.com. This can be used to check remote
connections to the MercuryiTC via RS232/Isobus, USB, Ethernet or GPIB.
The application is LabView based and the installer includes the LV run-time engine.
7.7 Programming examples
Further programming assistance and examples can be found on the Mercury support website
www.mymercurysupport.com. On the issue date of this manual, these include
• NI LabView VIs. This is a library of Vis for National Instruments LabView version 8.6 and
later.
• Communication with MagLab over ISOBUS. This document is a guideline on how to
establish communication between MagLab software and MercuryiTC over the serial ISOBUS
interface.
• Teslatron (OxSoft) Installer. This is an installation package including executable installer,
source code, MercuryiTC driver and an operation manual.
To Next Page
Loading...