MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 42
9 Calibrate
Tap once to calibrate this measurement circuit. This routine takes approximately one
minute. An error message is generated if the calibration fails for any reason.
10 Tap Home. The Home page is displayed. If the sensor has been configured correctly (and is
connected), the selected page will display a sensor reading.
4.2.2 To clear a widget configuration
1 Double-tap the widget on the Home page.
2 Tap the Device parameter box and select None from the drop-down menu.
3 Tap Assign.
The widget on the Home page should now display the name None.
To Next Page
Loading...
Need help?
General