MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 143
13.3 Connecting to the GPIB board
CABLE DISCONNECTION
Do not connect or disconnect GPIB cables while the computer, or
any of the instruments, are powered up. Equipment damage can
result if this precaution is not observed.
DÉBRANCHEMENT DU CORDON
Ne pas brancher ou débrancher des cordons de bus d'interface
général pendant que l'ordinateur, ou n'importe lequel des
instruments, est sous tension. Ne pas respecter cette précaution
risque d'endommager l'équipement.
1 Switch off electrical power to the iTC.
2 Switch off electrical power to all instruments and controllers that are connected to the GPIB.
3 Connect the iTC to the bus using a standard GPIB cable.
To Next Page
Loading...