MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 103
*CLS Clear Status Command
*ESE Standard Event Status Enable Command
*ESE? Standard Event Status Enable Query
*ESR? Standard Event Status Register Query
*OPC Operation Complete Command
*OPC? Operation Complete Query
*RST Reset Command
*SRE Service Request Enable Command
*SRE? Service Request Enable Query
*STB? Read Status Byte Query
*TST? Self-Test Query
*WAI Wait-to-Continue Command
The identification command IS supported...
*IDN? Identification Query
8.3.1 SCPI protocols
The commands are case-sensitive.
Keywords are a maximum of four characters long. Keywords longer than four characters
generate an invalid command response.
Keywords are separated by a colon: (ASCII 0x3Ah).
The maximum line length is 1024 bytes (characters), including line terminators.
All command lines are terminated by the new line character \n (ASCII 0x0Ah).
8.3.2 Reading the instrument identity
Send the command:
*IDN? (plus termination \n)
To Next Page
Loading...
Need help?
General