MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 51
10 Tap a cell in the table, then tap
to remove a complete row.
11 When the complete sequence is programmed, tap Save to save the programmed sweep as
a file.
12 Tap Close to return to the Control Loop Configuration page.
13 Tap Home to return to the Home page.
4.7.3 Loading a sweep
1 Tap Control on the Home page. The Control Loop Configuration page is displayed.
2 Select the required temperature sensor from the list in the Sensor parameter box.
3 Tap Sweep. The Sweep Table page opens.
4 Tap Load and select the filename of the sweep to be loaded.
4.7.4 Starting a sweep
1 Tap Control on the Home page. The Control Loop Configuration page is displayed.
2 Select the required temperature sensor from the list in the Sensor parameter box.
3 Tap the Set point button until it displays Sweep . The Set point parameter box value will
change as the sweep proceeds.
To Next Page
Loading...
Need help?
General