MercuryiTC
©2014 Oxford Instruments Omicron NanoScience. All rights reserved.
Page 81
all GUI controls are disabled. Set Remote Lock to Off to allow (normal) GUI control of the
iTC. However, the Settings features are disabled. The Remote Lock function may be
accessed remotely.
• Remote Access
Select Local from the drop-down menu to allow the user to control the iTC from the GUI.
Select an interface from the drop-down menu to enable remote control via the selected
interface.
• SCPI/Legacy parameter box
This parameter box is only displayed if an interface is selected in Remote Access.
Select SCPI to use a command set based on SCPI.
Select Legacy to use a command set that is compatible with legacy instruments.
The page contains the following buttons:
• Alarm
Tap once to access the Alarm Logs page (see section 16.1.1). If the text is RED an alarm
condition exists.
• Apply
Tap once to apply (save) changes made on this page.
• Home
Tap once to return to the Home page.
The General page also displays the firmware version in use.
To Next Page
Loading...
Need help?
General