Panasonic Firetracker FT128 - 33 Revision History; Operation Manual Revisions Table; Software Revision 2.4.4; New Brooks Display and Field Modules

Operation Manual
FT128 Rev 2.4
147
33 Revision History
33.1 Operation Manual Revisions Table
Issue Date Description
Written
By
Checked
By
Rev 0 16/04/07
Update the original MEW00509 Rev 2 document for
the Australian convention. 16/04/07
A.S. C.O.
Rev 1 15/01/09
Update the original MEW01091 Rev 1 document for
the Australian convention.
A.S. C. Orr
Rev1.1 24/03/09
Add general arrangement drawing and update wiring
diagrams
A.S. A.S.
Rev1.2 02/02/11 Add OWS details & update G.P. A.S.
Rev 2.0 27/11/13
Update to V2.0 software and add gas module option
AS / ET
AS
Rev 2.1 06/06/14
Update to include the features in V2.1 software,
A.S.
Rev 2.1.1 26/8/14
Change limitations in Table 3, page 14
A.S.
Rev 2.1.2 12/1/15
Minor update to add EBLWin V2.1.2 feature, transfer
drawings to separate document & keep only 2
drawings.
A.S.
Rev 2.2 12/08/15
Minor update, include V2.2.x software, added Local
Alarm Acknowledgement.
E.T.
A.S.
Rev 2.4 20/04/18
Update for S/W V2.4.X, add new 19” rack cabinet, new
Brooks 19”rack display and field modules.
A.S. /
E.T.
A.S.
33.2 Software Revision 2.4.4
33.2.1 New Brooks Display and Field Modules
Support a new series of BROOKS display modules for the new 19” rack systems. For more
details, refer to Chapter 5 “New 19” Rack Cabinet & New Loop Modules” page 28.
33.2.2 New and Enhanced Features
• Support some new products not released yet, will advise when become available
e.g. 4461, 4462, 4611, 4620, etc.
• Support new visual Alarm Devices 4480, 4481, 4482 and remote indicator 4418.
• Increase number of remote display units (1728 & 1736) to 30 units in FT1020G3
(still 8 in FT128).
• Increase number of zone Groups from 30 to 64.
• Increase number of short circuit isolators to 128.
• Disconnect / re-connect COM loop by just right-clicking on the loop in EBLWin.
• Toggle LED
• Automatic address setting
This is a new feature which enables the commissioning / maintenance technician
to automatically set addresses on a COM loop with units containing short circuit
isolators i.e. addresses 1-128 are allocated for the units with isolators. It also sets
the sequence number on all short circuit isolators.
For more details, refer to FT128 Technical / Programming Manual.