Panasonic Firetracker FT128 - Event Log (H4;U6)

Operation Manual
FT128 Rev 2.4
107
23.6 Event Log (H4/U6)
Three event logs (3 x 500 events) are available:
• Alarm log (alarm events, for example fire alarm, fire alarm reset, and so on)
• Interlocking log (interlocking events only)
• General event log (all other type of events)
The most recent event is shown in the top of the list. If there are no events --- List is empty
--- will be shown.
The initials of the person logged on to the system will also be shown for each event when
applicable (i.e. commands). Commands done via EBLWin and the Web-server will also be
shown.
Note: The event logging is disabled as long as menu H4/U6 is open.
Action Text in display Comments
"Access"
Log on to FT128 as shown in
page 35.
Scroll to menu H4.
Present system status
ACCEPT? H4
"A"
Disablement
ACCEPT? U1
Scroll to menu U6.
Event log
ACCEPT? U6
Press "A" to accept.
"A" Select event log: 0
0=Alarm 1=Interlocking 2=General
Select type of event log.
"0", "1" or "2"
"A"
When "A" is pressed, an event will be shown in the
display, e.g.:
The most recent event will
be shown, i.e. use “" to
scroll downwards in the list.
xxx:
"Blank" = FT128
Win = By EBLWin
Web = By Web-server
SP = By Service Personnel
FIRE ALARM zone 12 address 45
DD-MM HH:MM XX
or
FIRE ALARM zone 32
DD -MM HH:MM XX
or
FAULT: Output S1
Acknowledge DD -MM HH:MM XX
"Return" Select event log: 0
0=Alarm 1=Interlocking 2=General
Select type or press
"Return" to menu U6.
"Return" Event log
ACCEPT? U6
Scroll or press "Return" to
menu H4
"Return" Present system status
ACCEPT?H4
Scroll or press "Return"