Operation Manual
FT128 Rev 2.4
35
6.1.3 Password for Web-server Access only
Normally a password consists of 6 digits. This allows the same user to get access to the
control unit as well as to the web-server if both are selected.
If a user should have access to the web-server only, it is possible to choose a stronger
password. It consists of 6 to 10 characters and digits as well as letters can be used.
Note: The letters are case sensitive
6.2 Access Levels
To use the keypad in FT128 and get access to the menus, it is necessary to log in with a
user name and a password for level 2A, 2B or 3A.
Before any SSD is downloaded (e.g. in a brand-new control unit), only "0" is shown and
no password is required. After SSD download, the downloaded user names and
passwords will be valid.
6.2.1 How to Log On
a) Open the acrylic door with 003 key. Press the soft key Menu.
b) On the keypad, press 0, 1, 2 - - 8 or 9 to select a user. Press
c) Type the password for that user. (Six digits. * * * * * *)
21
After typing a correct password, a main menu list with the available menus will be
displayed. For "0", Information only, no password is required.
NO ACCESS!
No access will be shown if the password was incorrect. Try again.
Note: After three attempts with wrong passwords, the log in function will be blocked for
one hour for the user name respectively.
6.2.2 Navigation / General Procedures
• Scroll in lists or menus with .
• Press to toggle between different choices.
• Press A to select / accept.
• Press the digits on the numeric pad to choose a menu or enter data.
• A successful disablement is indicated by a beep and a "√". It will also be shown in
the Re-enable list.
• A non-successful disablement is indicated by another beep and a "X".
• To leave a menu press Return.
• To leave the menu system, press Return.
• To logout, close the door.
Quick jump can be used within each menu, e.g. press "6" for a quick jump to menu H6.
You will be automatically logged out 15 minutes after the last action, and directly when you
close the door. A new login is then required. If you leave the menu system without closing
the door, you have access to the menu system again only by using the "Menu" button. A
new login is not required.
21
Default password “000000” for information only, “111111” for building officer and “222222” for service personnel.
To Next Page
Loading...
