Operation Manual
FT128 Rev 2.4
139
29 Change Password (H10)
A password changed via menu H10 (+ H8/S5) will be valid until it is changed via menu
H10 again or it is erased via EBLWin (menu Tools / Reset user passwords).
If the valid password is unknown, EBLWin must be used to change the password.
Action Text in display Comments
"Access"
Log on to FT128 as shown
in page 35.
Scroll to menu H10.
Change access code for daily duties
ACCEPT? H10
"A"
Password: _
New Password: Verify:
Enter the old and new
passwords and the new
password again.
Password: ******
New Password: **** Verify: ******
The digits are replaced
(******) in the display.
Incorrect Password, NO change
Wrong password was
entered. Try again.
Password is changed
Correct password was
entered.
Change Password
ACCEPT? H10
Scroll or press "Return" to
log off.
Note: As long as you don't close the door you can enter the menu system again without
a password.
Note: After change of password, it is recommended to do a "Safe shutdown of the control
unit" (see menu H8/S7). This will save the SSW data (e.g. the new password) in a Flash
ROM (see page 82).
Use EBLWin to change the password(s) if they are forgotten.
To Next Page
Loading...
