4-22 System Programming
4.2.1 Tenant
Specifies “Start” time of DAY / NIGHT service on a
day of the week basis.
(This setting is valid when “Auto mode” is selected in
“DAY / NIGHT Switching Mode” setting)
[Note]
• Up to four time frames
(Day 1, Night 1, Day 2, Night
2)
can be set up on each day of the week.
Specifies the start time for Day Service 1.
Specifies the start time for Night Service 1.
Specifies the start time for Day Service 2.
Specifies the start time for Night Service 2.
Specifies the Music Source port to be used for Music
on Hold.
Specifies the Music Source port to be used for BGM.
Specifies whether to utilize ARS (Automatic Route
Selection) or not.
If set to “No” (No check), “Idle Trunk Dial Access” is
activated instead of ARS when an extension user dials
“9” for making an outside call.
Enables or disables “Toll Restriction Override for
System Speed Dial Numbers” feature.
If enabled (Check), all extension users in the tenant can
make System Speed Dialing calls without toll
restriction.
Parameter
Value Range
(default)
Description/Function Reference
External
Paging
Sec. 4.4.5
ARS
Sec. 4.7
Toll
Restriction
Override for
System Speed
Dialing
(F/G)
1. Disable
2. 12:00-11:59
PM/AM
(8:00 AM)
Same as Day 1
(5:00 PM)
Same as Day 1
(Disable)
Same as Day 1
(Disable)
1. None
2. MUS1
3. MUS2
(MUS1)
1. None
2. MUS1
3. MUS2
(MUS1)
1. Check
2. No check
(No check)
1. Check
2. No check
(No check)
(Auto Start Time)
Day 1
(SUN-SAT)
Night 1
(SUN-SAT)
Day 2
(SUN-SAT)
Night 2
(SUN-SAT)
Music on Hold
Source
BGM Source
Automatic Route
Selection
System Speed
Dial TRS Level
Override
To Next Page
Loading...
