System Programming 4-21
4.2.1 Tenant
Specifies the tenant number which you are going to
program.
Specifies the Day/Night switching mode, Manual or
Auto.
1.
Manual
The Manager or an Operator can switch Day/Night
mode at any time desired by dialing the feature
number for “Night Mode set/cancel.”
2.
Auto
The system automatically switches the Day/Night
mode each day at the time programmed in Auto Start
Time.
Specifies other tenant numbers to which extensions in
this tenant can make a call.
If no tenant numbers are checked in this field, extension
users within this tenant
cannot make a call to extensions
in other tenants.
Making calls from one tenant to another is not allowed
by default.
Used to assign various parameters on a tenant (1 - 8) basis.
Parameter
Value Range
(default)
Description/Function Reference
Tenant Service
(F/G)
Night Service
(F/G)
None
1-8
(1)
1. Manual
2. Auto
(Manual)
1. No check
[Disallowed]
2. Check
[Allowed]
(No check)
Tenant No.
DAY/NIGHT
Switching Mode
Inter-tenant
Calling (1 - 8)
To Next Page
Loading...
