System Programming 4-5
4.1.1 Slot Assignment
4.1.1.1 Properties (DHLC/ESLC/DLC)
Used to set the parameters for the following extension cards :DHLC, ESLC,DLC
Parameter
Value Range
(default)
Description/Function Reference
1.
Type-A: Normal
2.
Type-B: New
Zealand
3. Type-C: Sweden
(Type-A)
1. 16 - 96 msec
2. 16 - 136 msec
(16 - 96 )
1. Yes
2. No
(Yes)
Pulse Type
% Break
Detection
Flash
Detection
Dial Pulse Signal type is fixed to “Type-A: Normal.”
Specifies the Pulse Break Detection length.
Dialed digits from a dial pulse type SLT is transmitted
to the system by making and breaking a loop current,
thereby interrupting loop current. Duration time
required to detect the number of breaks may vary
depending on the type of SLT connected.
(Assignable for DHLC and ESLC only.)
Activates or deactivates the detection of Flash signal
transmitted from an SLT.
If set to “No,” the system does not recognize a
hookswitch flash.
(Assignable for DHLC and ESLC only.)
To Next Page
Loading...
