Panasonic KX-TD500 - Amphenol 57 JE Type Connector

■ To connect Amphenol 57JE type (screw-attach-type 50-pin connector) to the Option
Card, follow the procedure below.
2.1.4 Amphenol 57JE type connector
2-6 Installation
1. The 50-pin connector (jack) on the Option
Card has two hook-pins.
Remove the upper hook-pin, taking out
the screw.
2. To attach the Amphenol 57JE type (plug) to
the connector, drive the accessory Screw at
the upper part, and fasten the accessory
Wire Tie around the lower hook-pin and the
Amphenol 57JE type, as shown.
Accessary
Screw
57JE type
Accessary
Wire Tie
Accessary
Wire Tie
Accessary
Screw
50-pin connector
Accessary
Screw
Amphenol
57JE tyoe
Hook-pin
Hook-pin
50-pin
connector
Amphenol 57JE type
When connecting a connector of the type shown
below, unscrew the lower hook-pin, too. Then drive
both accessory Screws.
Option Card
Option Card
50-pin connector
Screw
Hook-pins