Panasonic KX-TD500 - Page 143

4-4 System Programming
4.1.1 Slot Assignment
Parameter
Value Range
(default)
Description/Function Reference
DID-2W : Both-way DID Card
DID-MFC : MFC DID Card
E&M : TIE Line Card
T-1 : T-1 Digital Trunk Card
E-1 : E-1 Digital Trunk Card
BRI : ISDN Basic Rate Access Interface Card
PRI30 : ISDN Primary Rate Access Interface Card
DPH : Doorphone Circuit card
AGC : Automatic Gain Control Trunk card
DISA : Direct Inward System Access Trunk card
RMT : Remote Circuit card
ERMT : Enhanced Remote Circuit card
[Notes]
• To change the current Card Type to a new one, delete
the current setting first by selecting “None” and then
assign a new Card Type.
•
CPU - Slot No.13 of the Basic Shelf is fixed to CPU
(Central Processing Unit) card.
• TSW- Slot No.14 of the Basic Shelf is fixed to TSW
(T-Switch) card.
Used to set the status of the service cards.
INS: The target service card is operating normally.
OUS: Programming data for the target service card
is entered, but the target service card is not
assigned to the system.
FAULT: The target service card is defective (hardware).
In this case, the LED indicator on the
service card is lit.
1. INS
2. OUS
3. FAULT
Card Type
Status