4.6 [2-4] Week Table—Time Setting
The
start times of 4 different time blocks can be programmed for each day of the week, for the selected Time
Table, as well as the start and end times of up to 3 break periods.
1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—Setting
Enables the setting of the start time for each time block.
Default
Day 1 Start, Night Start: Enable
Lunch Start, Day 2 Start: Disable
Value Range
Disable, Enable
Maintenance Console Location
4.6 [2-4] Week Table—Time Setting
Programming Manual References
None
Feature Manual References
17.1.3 Tenant Service
17.1.5 Time Service
1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—Hour,
Minute
Specifies
the start time for each time block. Times can only be set when
1. Day/Lunch/Night—Day1
Start,
Lunch Start, Day2 Start, Night Start—Setting is set to Enable.
Default
Day1: 9:00
Lunch: 12:00
Day2: 13:00
Night: 17:00
Value Range
00:00–23:59
Maintenance Console Location
4.6 [2-4] Week Table—Time Setting
Programming Manual References
None
270 PC Programming Manual Document Version 2010-11
4.6 [2-4] Week Table—Time Setting
To Next Page
Loading...
