Panasonic KX-TDA50

10.1 [8-1] System Setting
Automatic Route Selection (ARS) automatically selects the appropriate carrier at the time a CO line call is
made, according to the programmed settings. The user
-dialed number will be checked and modified in order
to connect it to the appropriate carrier.
ARS Mode
Selects the condition to determine when to operate ARS.
Default
Off
Value Range
Off: ARS is disabled.
On for Local Access Operation: ARS operates when an extension user makes a call using Idle Line Access
method.
On
for Any CO Access Operation: ARS operates when an extension user makes a call using Idle Line Access,
CO Line Access, or S-CO Line Access method.
Maintenance Console Location
10.1 [8-1] System Setting
Programming Manual References
None
Feature Manual References
3.1.14 CO Line Access
1.1.3 ARS (Automatic Route Selection)
Mode When Any Carrier is not programmed for the Dial
Selects what happens when the dialed number is not found in Leading Number in 10.2 [8-2] Leading
Number.
Default
Local Access
Value Range
Disconnect: the line will be disconnected.
Local Access: the dialed number will be handled by Idle Line Access method.
Maintenance Console Location
10.1 [8-1] System Setting
Programming Manual References
None
706 PC Programming Manual Document Version 2010-11
10.1 [8-1] System Setting