2.6.17 Utility—System Reset—Reset by the Command
Updates
the main system program and data files stored within the PBX using files taken from the SD memory
card, and resets the connected PBX.
This option is only available at Installer level.
2 copies of each of the main system files can be stored on the SD memory card. The names of these files are
as follows:
KX-TDA50
File Name Description
DSSYS Main system data file. Contains all of the current configuration data for
the PBX.
DSSYS_S Backup main system data file
PSMPR PBX program file. Contains the software to run the MPR board of the
PBX.
PSMPR_S Backup PBX program file
KX-TDA100/KX-TDA200
File Name Description
DSYS Main system data file. Contains all of the current configuration data for
the PBX.
DSYS_SUB Backup main system data file
PMPR PBX program file. Contains the software to run the MPR board of the
PBX.
PMPR_SUB Backup PBX program file
KX-TDA600
File Name Description
DLSYS Main system data file. Contains all of the current configuration data for
the PBX.
DLSYS_S Backup main system data file
PLMPR PBX program file. Contains the software to run the EMPR
board of the
PBX.
PLMPR_S Backup PBX program file
When new DSYS/DSSYS/DLSYS and PMPR/PSMPR/PLMPR files are transferred from a connected PC to
the SD memory card using the File Transfer PC to PBX (SD Card) utility (see 2.6.2 Utility—File Transfer
PC to PBX (SD Card)), they are stored as the backup files. To use these files on the PBX, it is necessary to
first swap them with the currently active files on the SD memory card.
Requirements
• This utility only functions on PBXs version 1.005 and later.
• On earlier versions, the reset request confirmation screen will be displayed, and files will not be updated.
Document Version 2010-11 PC Programming Manual 57
2.6.17 Utility—System Reset—Reset by the Command
To Next Page
Loading...
