Group Forward Set
Enables setting call forwarding for calls to an incoming call distribution group.
Default
Enable-Group
Value Range
Disable: An extension cannot set call forwarding for any group.
Enable-All
: An extension can set call forwarding for all groups.
Enable-Group: An extension can only set call forwarding for the group to which the extension belongs.
Maintenance Console Location
4.11 [2-7-1] Class of Service—COS Settings
Programming Manual References
5.13 [3-5-1] Incoming Call Distribution Group—Group Settings—Member List
6.1 [4-1-1] Wired Extension—Extension Settings—Main—
COS
6.10 [4-2-1] Portable Station—Extension Settings
—Main—
COS
Feature Manual References
6.1.6 FWD (Call Forwarding)
Programming Mode Level
Specifies the level of authorization for performing PT programming.
Default
PROG Only
Value Range
Disable: A PT user cannot perform any programming.
PROG Only: A PT user can perform only personal programming.
PROG and PROG **/*#: A PT user can perform both personal and system programming.
Maintenance Console Location
4.11 [2-7-1] Class of Service—COS Settings
Programming Manual References
6.1 [4-1-1] Wired Extension—Extension Settings
—Main—
COS
6.10 [4-2-1] Portable Station—Extension Settings
—Main—
COS
Feature Manual References
13.1.29 PT Programming
Document Version 2010-11 PC Programming Manual 323
4.11 [2-7-1] Class of Service—COS Settings
To Next Page
Loading...
