to incoming CO line calls routed through public networks when the type of network numbering plan is Unknown
or not specified.
A maximum of 4 Length of Digits Modification Tables can be programmed. Select the desired table from the
Modification Table list.
If
the length of digits of an incoming CO line call is less than the
Minimum Caller ID Digits (for National),
the caller’s number is not modified.
Minimum Caller ID Digits (for International)
Specifies
the minimum number of digits required in the caller’s number for it to be recognized as an international
call. The value specified here must be larger than
Minimum Caller ID Digits (for National).
Default
12
Value Range
1–31
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—
Calling Party
number—Type of Number
—Public, Private
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—
Called Party number
—Type of Number—Public, Private
Feature Manual References
3.1.1 Caller ID
Minimum Caller ID Digits (for National)
Specifies the minimum number of digits required in the caller
’s number for it to be recognized as a national
call. The value specified here must be smaller than
Minimum Caller ID Digits (for International).
Default
8
Value Range
0–30
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—
Calling Party
number—Type of Number
—Public, Private
Document Version 2010-11 PC Programming Manual 393
5.3 [3-1-3] Caller ID Modification
To Next Page
Loading...
