Incoming Call Wait Timer for Extension Caller ID
Specifies the length of time that the ringing for a call is delayed when the call follows immediately after the
previous unanswered call. When receiving two calls in quick succession (e.g., when a call waiting in a queue
is
directed to an extension immediately after the previous unanswered call stops ringing), some SLTs require
a pause, after the first call stops ringing, to receive the second call’s Caller ID information.
Note that for the KX-TDA50, the setting of this parameter is only effective when a resource for sending
extension Caller ID is assigned in
Extension Caller ID Resource-1, 2 (KX-TDA50 only) for the port in
4.18 [2-10] Extension CID Settings.
Default
0
Value Range
0–15 s
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
4.18 [2-10] Extension CID Settings—
Extension Caller ID Resource-1, 2 (KX-TDA50 only)
Feature Manual References
3.1.1 Caller ID
SLT MW Mode (KX-TDA100/KX-TDA200/KX-TDA600 only)
Enables the use of the Message Waiting Lamp on an SLT extension connected to the extension port.
Default
Disable
Value Range
Disable, MW-Lamp
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
11.1.3 Message Waiting
Document Version 2010-11 PC Programming Manual 521
6.1 [4-1-1] Wired Extension—Extension Settings
To Next Page
Loading...
