Panasonic KX-TDA50

CO-CO with DISA—DISA to Private Network
Specifies whether the DISA port of the message card is released when a CO
-to-TIE line call using DISA is
established.
To enable this setting, "
CO-CO with DISA—Fwd/Transfer to Private Network" on this screen should be
set to "Enable".
Setting
this to "Disable" will free up DISA ports faster, but prevent DISA being used to detect the end of a call
and disconnect the CO line quickly.
Default
Disable (Release DISA)
Value Range
Disable (Release DISA): The DISA port of the message card is released when a CO-to-TIE line call using DISA
is established.
Enable: DISA stays connected for the duration of the call, to allow detection of the end of the call.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
7.3 [5-3-1] Voice Message—DISA System—Option 1—
CO-CO with DISA—Fwd/Transfer
to Private Network
Feature Manual References
None
CO-CO with DISA—Fwd/Transfer to Public CO
Enables CO-to-CO line calls to be established using DISA.
Default
Disable
Value Range
Disable: CO-to-CO line calls are established without using DISA.
Enable (Get DISA)
: CO-to-CO line calls are established using DISA, and DISA can be used to detect the end
of the call.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
7.3 [5-3-1] Voice Message—DISA System—Option 1—
CO-CO with DISA—DISA to Public CO
Feature Manual References
None
Document Version 2010-11 PC Programming Manual 661
7.3 [5-3-1] Voice Message—DISA System